I use the mriscoc “professional” firmware , but I’ve enabled certain configurations that have to be done in the programmer. Note that this is a “Marlin” firmware.
Here’s the options enabled. I can help you out if you ever need it by the way (if you are not Mike this sentence does not apply to you).
- Support a higher temperature by using the Volcano AKA T5 thermistor setting (ATC Semitec 104GT-2/104NT-4-R025H42G)
- Full beeper
- Enable the BLTouch (with UBL bed leveling)
- Linear Advance Enabled (also known as Pressure Advance)
- Tuning guide for this can be found on the ellis3dp page
- Input Shaping Enabled
- [MPC Enabled](https://github.com/mriscoc/Ender3V2S1/wiki/Model-Predictive-Temperature-Control-(MPC) (better temperature control than PID)